Setting up a Brick Paver Walkway or Interlocking Brick Machine

The usage of Bricks or Pavers to develop a sidewalk or patio area matches a home in a method that is unmatched. In addition, setting up a Brick or Paver walkway does not always require a pro.

The secret to setting up a Brick or Paver Walkway is to very first correctly prepare the area where the bricks/pavers are to be installed. In addition, string lines need to be strung on each side of the sidewalk.
Once the location has been dug down, 3/4" gravel stone need to be laid in and tamped down tightly. 2" of sand, or stone dust should be spread over the gravel. Once again the sand/stone dust need to be tamped down. Stone dust is chosen. The height between the tamped down sand and the stringline must equal the thickness of the brick or paver.

Now that you have a steady base, put a 1" pipeline or ledger board the length of the pathway on either side of the walkway. Utilizing a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will create a level area to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared location. These strips will act as your sidewalk border and aid to keep the website stability and shape of the sidewalk.

You can then start to lay the bricks/pavers as soon as this is done. There are lots of patterns you can lay. I especially like the Herring Bone pattern. The secret to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once again assist preserve the integrity of the walkway.

Inevitably bricks/pavers will require to be cut or split when constructing the pathway. To in fact cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the spot where you desire to break the brick. If your pathway has curves you will require to buy/rent a wetsaw.

After installing the bricks, develop the outside edges with extra sand, and then shovel in the topsoil and pack down strongly.
Spread stone dust over the new pathway and sweep into the fractures. This will finish the interlocking of the bricks and help to get rid of any weed development.


In addition, setting website up a Brick or Paver walkway does not necessarily need a pro. The key to setting up a Brick or Paver Walkway is to first correctly prepare the location where the bricks/pavers are to be set up. Now that you have a steady base, place a 1" pipe or ledger board the length of the pathway on either side of the sidewalk. These strips will act as your sidewalk border and help to maintain the integrity and shape of the pathway. Undoubtedly bricks/pavers will require to be cut or split when building the sidewalk.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments on “Setting up a Brick Paver Walkway or Interlocking Brick Machine”

Leave a Reply

Gravatar